Peachtree Woodworking Supply Delta UHMW Zero Clearance Table Saw Insert Approx Dims 13-3/8in x 3-3/4in x 1/2in

Peachtree Woodworking Supply Delta UHMW Zero Clearance Table Saw Insert Approx Dims 13-3/8in x 3-3/4in x 1/2in

The insert is blank so you can custom fit the blade slot for standard Kerf, Thin Kerf or Dado blades Helps to prevent tear-out and closes the large factory gap between blade and insert. Insert comes with leveling screws and rear safety pin 13 3/8" x 3 3/4" x 1/2" thick- Made of UHMW Please check your Length,Width and Thickness of your current insert before ordering Replace your factory table saw insert with a UHMW zero clearance insert. Zero Clearance inserts help prevent kickback and tear-out on your stock pieces when feeding through a table saw blade. By raising your blade up through the insert, you eliminate gaps between the side of the insert and the blade. This provides with much better stock support than with most factory inserts that come with the saw. This also prevents smaller stock pieces from falling into the opening that exists with factory inserts. Zero clearance inserts can be used with any type of standard carbide tipped saw blade (standard or thin kerf blades) and can also be used with dado blades. It is recommended that if you need an insert to accommodate both a standard saw blade and a dado blade, that you purchase two separate zero clearance inserts. Use one for your normal cuts and one for dado cuts.