CONFAST LDC384 3/8" x 4" Zinc Plated Large Diameter Concrete Screw for Anchoring to Masonry, Brick or Block (25 per Box)

CONFAST LDC384 3/8" x 4" Zinc Plated Large Diameter Concrete Screw for Anchoring to Masonry, Brick or Block (25 per Box)

WILL CUT ITS OWN THREAD INTO CONCRETE - When inserted in to properly drilled hole WILL CUT ITS OWN THREAD INTO CONCRETE - When inserted in to properly drilled hole LOW TORQUE THREADS - easy installation SERRATED HEX WASHER HEAD - Prevents back-out SINGLE PIECE DESIGN - No assembly required; ready to install USE A ANSI STANDARD CONCRETE BIT - 3/8" bit, size is the same as the anchor diameter Applications
The anchor is made from Carbon Steel, and is Zinc Plated. This anchor is designed for use in Concrete, Brick or Block.

Environment
The anchor is designed for use in a Dry environment.

Head Style
The anchor is a Hex Washer Serrated head and is designed to allow the head to sit on top of the surface of the item being attached.

Hole Diameter/Bit Diameter
The anchor requires a 3/8" hole to be drilled in the base material (Concrete). The hole should be drilled with carbide tipped bit using a hammer drill.

Driver Required
A 9/16" nut driver is required for driving the anchor into the base material.

Diameter of Anchor
The diameter of the anchor is 3/8".

Length Anchor
The length of the anchor is 4"

Minimum Embedment
The minimum anchor embedment into the concrete is 1-1/2". Therefore, the anchor must be installed so that a minimum of 1-1/2" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 2-1/2". This will ensure that the minimum embedment of 1-1/2" will be met.

Fixture Hole Diameter
To fasten an object using these anchors, the hole in the object must be at least 7/16" to accomodate the 3/8" anchor. If the hole is not at least 7/16" the anchor will not fit through.

Spacing between Anchors
Each anchor must be spaced a minimum distance of 6" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 3" from an unsupported edge of the concrete.