Silicognition wESP32 - ESP32 with Isolated Ethernet and 13W IEEE 802.3at PoE, 16MB Flash, MicroPython, Arduino, ESP-IDF Compatible

Silicognition wESP32 - ESP32 with Isolated Ethernet and 13W IEEE 802.3at PoE, 16MB Flash, MicroPython, Arduino, ESP-IDF Compatible

ESP32-WROOM-32E module with 16MB flash, MicroPython pre-loaded IEEE 802.3at Type 1 Class 0 PoE with 13 W of power 12 V (optional 5 V) and 3.3 V power output High performance, reliable RTL8201 Ethernet PHY Compact size, high-quality 4-layer PCB Compatible with ESP-IDF, Arduino, MicroPython, and various other firmwares All revisions fully supported by ESPHome version 2022.12 upwards Qwiic connector for solderless applications The wESP32 is an ESP32 core board with wired Ethernet connectivity and Power over Ethernet that was designed to help Makers quickly create zero-setup, single-wire-install connected devices. By combining a powerful microcontroller with excellent community support, 13 W of power, and reliable connectivity in a compact footprint, the wESP32 gives you a head start in your next IoT design and allows you to focus on your application.

Newest revision 8 with RTL8201 PHY and Qwiic connector!

- Espressif Systems ESP32-WROOM-32E dual core 240 MHz with 16 MB of flash.
- Optional wESP32-Prog module for programming and/or USB serial console can be plugged in as needed or soldered in permanently.
- IEEE 802.3at Type 1 Class 0 compliant PoE with 12.95+ W of power available at the default 12 V output setting for V+.
- Optional 5 V output setting for V+ configurable by solder jumper with 5 W of power available.
- 3.3 V output with up to 6 W output power available (power taken from V+).
- Applying external power to V+ is supported, in case PoE is not available.
- Applying power through the wESP32-Prog[-C] USB port is supported (5 V or optional 12 V for Type C on V+).
- High performance RJ-45 jack and RTL8201 PHY with optimized data path for excellent data throughput.
- Compatible with PoE Mode A (power over data pairs) and PoE Mode B (power over spare pairs) and Auto-MDIX allowing the use of straight and cross-over Ethernet cables.
- Designed with full data and power path isolation to comply with the IEEE 802.3at 1500 Vrms isolation requirement.
- 802.11b/g/n WiFi and Bluetooth 4.2/LE for use as PoE wireless IoT access point.
- High quality 4-layer PCB and mounting hole designed to sink heat away from the PoE PD controller for optimal thermal performance.
- 20-pin header footprint with 3.3 V, V+ power and 15 of the ESP32 GPIOs available for your application.
- Qwiic connector on revision 8 for solderless applications.
- Compact 75 mm by 40 mm footprint with 4 mounting holes compatible with common M2.5 or 4-40 screws.