SUPROJDM for DELTA ROCKWELL NEW MANUFACTURING BANDSAW BLADE 2-1/2" X 3/32" 2 TWO PACK 6061 ALUMINIUM

SUPROJDM for DELTA ROCKWELL NEW MANUFACTURING BANDSAW BLADE 2-1/2" X 3/32" 2 TWO PACK 6061 ALUMINIUM

2 Solid Aluminum Band Saw Table Inserts, Fits: ROCKWELL/DELTA Milwaukee Band Saw, Dimensions: 2 1/2" Diameter X 3/32" Thick, Fits Most Delta Models and Many Other Brands. Diameter approximately 63MM Replacing the platen provides better support, stability and precision for the workpiece being cut. Before purchasing, measure the saw table inserts on your bandsaw to make sure your bandsaw can accommodate 2-1/2" diameter inserts. To lock the board and prevent it from rotating, metal punches can be used on the edges of the board to create bumps or nipples on the right or left side of the board. Due to slight differences in the size of the board holes in the different models of band saws that use this board, it may be necessary to lightly sand the edges of the board to fit. Note-1: A Metal Punch can be Used on the Edge of the Plate to Create a Bulge or Nipple on the Right or Left Hand Side of the Plate that will Lock the
Plate and Keep it from Spinning.
Note-2: If your Bandsaw Table Plate Cavity has a Indexing Pin. A Notch will need to made in the Aluminum plate to accommodate the Pin. This can be
done by a Hacksaw or the Bandsaw itself and will not hurt the blade, the plate being aluminum. It will then Stabilize the Plate and keep it from Rotation
Because of the Slight Variance of the size of the Plate Hole in the different Models of Bandsaw's,that use this Size of Plate, there could be the need to
lightly sand the edge of the Plate for the Proper Fit