PROfezzion [164'] Wireless Shutter Release Remote Control for Sony A7IV A7II A7 A6600 A6500 A6400 A6300 A6100 A7R A7RII A7RIII A7RIV A7RV A1 A1 II A9

PROfezzion [164'] Wireless Shutter Release Remote Control for Sony A7IV A7II A7 A6600 A6500 A6400 A6300 A6100 A7R A7RII A7RIII A7RIV A7RV A1 A1 II A9

[Compatibility] - Suit for Sony A6600, A6500, A6400, A6300, A6100, A6000, A5100, A5000, A1, A1 II, A9, A9II, A9III, A7, A7 II, A7 III, A7 IV, A7R, A7R V, A7R II, A7R III, A7R IV, A7S, A7S II, A7S III, A58, HX90, HX60, HX50, HX40, RX100 VII, RX100 VI, RX100 VA, RX100 V, RX100 IV, RX100 III, RX10 II, RX10 III, RX10 IV, ZV-1 FX30 [2.4GHz frequency & 16 channels]- This series remote control works at 2.4GHz frequency and has 16 available channels. It reduces camera shake and allows you to take pictures of subjects that are difficult to approach [Composition]- The unit includes three parts: a transmitter, a receiver, and a connecting cable. The transmitter and receiver are powered by two AAA batteries respectively. Its transmitter can trigger the receiver without a direct line of sight up to 50m / 164' when the receiver is connected to your camera [5 Shooting Modes]- By using this remote control, five shooting modes can be achieved: single shot, 5 seconds delay shot, 3 continuous shots, unlimited continuous shots, and bulb shot. Additionally, the transmitter is able to fire multiple receivers at the same time (Attention: It does not control video Start/Stop) [1/4"-20 Tripod Socket on the Bottom]- The receiver features a 1/4"-20 tripod socket on the bottom, so you can even mount it onto a tripod. All those features above make it a good partner for you to eliminate camera shakes and take creative pictures

Package Includes:

PR-UN1 Transmitter x 1

PR-UN1 Receiver x 1

AAA Battery x 4

Connecting Cable x 1

Removable Clip x 1

Lanyard x 1

Instruction Manual x 1

Simple Operation - How to use:

1. Install the AAA battery included to both the receiver and the transmitter. (Make sure to remove the plastic protective paper on the battery before installation)

2. Set the receiver and transmitter to the same channel (Normally the channel is already matched when you receive the package, so actually you don't need to set it, but if you ever reset the channel, make sure they are the same)

3. Once the batteries are properly installed and the channels are matched, when you press the shutter button on the transmitter, both the LED bulb on the transmitter and receiver will light up. (If not, please check if the battery is installed correctly or the battery is dead)

4. Once the transmitter matches the receiver, connect the receiver to the camera via the camera connecting cable which is included in the package, then set the transmitter into the working mode you want and finally press the shutter button to take a photo wirelessly.

Attention Please: This remote does not work when the camera is in movie mode, so it cannot control video start and stop!