Sand Spike Boat Anchor Pole for Boats, Jet Skis, Pontoons, and Kayaks, Large and Small Slide Pole System for Shallow Water, Sandbars, Beaches, and

Sand Spike Boat Anchor Pole for Boats, Jet Skis, Pontoons, and Kayaks, Large and Small Slide Pole System for Shallow Water, Sandbars, Beaches, and

BUNGEE CORD SELF-HAMMERS DEEP WITHOUT TOOLS: No mallet, no drill, no screw anchor. Press the tapered blade into any sand, soft or hard packed, and the bungee cord drives it deeper with each pull. Sets in seconds, holds boats up to 30 ft. HOT-DIPPED GALVANIZED STEEL BUILT FOR SALTWATER: Blade and shaft are hot-dipped galvanized steel, a corrosion-resistant finish built for salt and freshwater. The rubber grip handle withstands UV, saltwater, and repeated use season after season. STEEL TIE-DOWN LOOP FITS ANY DOCK LINE OR ROPE: The wide-gauge steel loop at the base of the handle accepts any size dock line or rope. Secure a pontoon, bass boat, kayak, canoe, or multiple small watercraft to a single spike in under a minute. STORAGE BAG KEEPS SAND OFF THE BOAT: The reinforced bag stores the spike after removal, keeping wet sand off the deck. Works as a surf fishing sand spike for rod holders and for beachside anchoring wherever sand can hold a stake. TWO SIZES FOR ANY WATERCRAFT: The 22 ft version has an orange handle and 40 inches total length for boats, kayaks, and canoes. The 30 ft version has a green handle and 51 inches total length for pontoons and larger vessels. Select your size above. Pull up to any beach or sandbar, step off the boat, press the spike into the sand, and the bungee cord does the rest. No mallet, no drill, no screwing anything into the ground. The tapered blade penetrates soft sand with hand pressure alone. The included bungee cord then hammers the spike deeper with each wave or boat pull, locking it in place without needing to reset. When the day is done, pull it straight out and store it. Blade and shaft are hot-dipped galvanized steel for long-term corrosion resistance in salt and freshwater. The rubber grip handle stays secure in wet hands. A wide steel tie-down loop at the base accepts any dock line, rope, or tether for securing a pontoon, bass boat, kayak, canoe, or multiple small watercraft to a single spike. The reinforced storage bag is included to contain wet sand on removal and keep the deck clean after use. Works equally well as a surf fishing sand spike for rod holders, a shore anchor at a lake launch, or a beach stake wherever sand can hold a post. Available in two sizes. The 22 ft version has an orange rubber handle and 40 inches total length, built for boats, kayaks, and canoes up to 22 ft. The 30 ft version has a lime green handle and 51 inches total length for larger boats, pontoons, and bass boats up to 30 ft.