Lumencraft LED Conversion Kit Compatible/Replacement for Maglite Flashlight - 4800 Lumen, fits 5-6 D Cell - High Power Upgrade for Maglight with 12x

Lumencraft LED Conversion Kit Compatible/Replacement for Maglite Flashlight - 4800 Lumen, fits 5-6 D Cell - High Power Upgrade for Maglight with 12x

BREATHE NEW LIFE INTO YOUR MAGLITES: This replacement bulb module gives your trusty old flashlights the make over they deserve. Turns them into a 4800 lumen torch with no tools or modifications required. INCREASED BRIGHTNESS: Over 26x brighter than a standard 178 lumen 6D incandescent Maglite, 12x latticepower high intensity LED emitters make it easy to see a large area and good distance. Up to 4800 lumens brightness and 144 meters beam distance. INCREASED BATTERY LIFE: Highly efficient LEDs increase run times for up to 130 hours burn time on low mode. FITS NEWER INCANDESCENT MAGLITES WITH "D" IN THE SERIAL NUMBER: Including those with MAGNUM STAR BI-PIN BULBS (see product photos for details). Does *NOT* fit Maglites that are LED from the factory. USER DEFINED MODES: By default the bulb is pre-programmed to be a simple easy to use 3 mode H,M,L with memory. However if you want to you can change it to have more or less output modes, and/or a strobe function. If you don't want additional features no programming is needed (See photos for detailed instructions).

Instantly convert your incandescent  Maglites into a SUPER POWERED LED flashlight! Twelve Latticepower High Intensity LED emitters and the Lumencraft 6080ma driver pound out up to 4,800 retina searing lumens (output of the bulbs is based on use of NIHM rechargeable cells). Alkaline cells will power the bulb up at a reduced output so are best used as backup). 

This bulb is for use with the voltage of 5-6D cells ONLY. 5-6x NIMH cells are best, or TWO high drain 3.7 volt li-ion such as a 26650. 

USER INTERFACE: By default the bulb is set to have 3 levels of brightness, Low, Medium, High. To select the output mode half press the Maglite switch until the light comes on, quickly let off and half press the switch again. Each time you do so the bulb will change output. Once you find the brightness level you want fully "click" the switch into place. The bulb will memorize the last mode used and come on in that mode when you power it back on.  You can see a video on how it works by searching Youtube for "Adventure Sport user interface".

ADDITIONAL FUNCTIONS: You can also reprogram the bulb to a very wide range of other brightness levels and mode groups. A full set of instructions on this is in the set of pictures above. 

HOW TO INSTALL: Start by unscrewing and removing the head of your Maglite flashlight. Next remove the factory reflector, bulb retaining ring and bulb from the switch tower (if you have the bi-pin bulb you can press down on the tower to eject the plastic bulb holder). Next remove the bezel and lens from the top of the Maglite head. Insert the 4,200 lumen bulb into the head. Place the lens over the dropin and thread the bezel back down until snug. Screw the head back on to the maglite until it is just "snug" onto the body.