FNIRSI USB Tester 4-24V 6.5A LCD USB A&C Voltage Current Power Display Multimeter with App Software, Fast Charge Detection Trigger, PD2.0/PD3.0,QC2.0/

FNIRSI USB Tester 4-24V 6.5A LCD USB A&C Voltage Current Power Display Multimeter with App Software, Fast Charge Detection Trigger, PD2.0/PD3.0,QC2.0/

【Color Screen USB Tester】FNIRSI FNB48P USB tester has a 1.77-inch full-color ultra-wide viewing angle TFT LCD display and APP software, integrated USB-A, Micro-USB, Type-C interface. Gravity sensor, automatically switch the display direction 【Multifunction USB Digital Tester】FNB48P uses external 16-bit ADC, PD protocol physical chip. It can monitor the voltage, current, power, resistance, capacity, temperature, D+/D- voltage etc, it can be used to test the fast charging protocol of chargers 【Fast Charge Protocol Trigger Detection】FNB48P supports trigger detection of various fast charging protocols, QC2.0/QC3.0 trigger, FCP/SCP trigger, AFC trigger, PD2.0/3.0 trigger, VOOC/WARP trigger, Super VOOC 1.0/2.0 trigger 【Parameter Detection and Recording】Six-digit display of voltage, current and power, the resolution is 0.00001 (V/A/W). 10 sets of switchable capacity, power and time statistics. 1 set of voltage and current curve records 【Other detection functions】The internal resistance measurement of the wire by the differential pressure method. E-Marker Cable chip reading. DASH Cable data reading. Record of startup time. Onboard temperature measurement. PD monitor. Analog DASH cable 【Widely Use】It can be used to measure the power supply or power consumption such as USB interfaces, mobile phone chargers, and U disks.Support low waveform drawing, 2sps->100sps sampling rate. Support high ripple drawing up to 3.2M sps sampling rate

FNB48P USB tester is a reliability and USB voltage andcurrent detection meter and a mobile communication terminal fast chargingtrigger.

It has a 1.77-inch full-color ultra-wide viewing angle TFT LCD display, integrated USB-A, Micro-USB, Type-C interface.

Use external 16-bit ADC, PD protocol physical chip.

It can be used to measure the power supply or power consumption of products such as USB interfaces, mobile phone chargers, and U disks.

It can be used to measure the charging power of mobile phones and the input and output of mobile power supplies. 

It can be used to test the fast charging protocol of chargers.

This instruction manual includes relevant safety information, warningtips and solutions to common abnormal situations. 

Please read the relevantcontent carefully and strictly abide by all warnings and precautions.

Do not connect the monitoring interface to a power supply exceeding 24V.

Do not connect the PC connection port to a power source exceeding 16v.

Only one pair of monitoring interfaces (one input port,one outputport) can work at the same time. When there is a pair of monitoring interfaces working, it is forbidden to connect to the equipment onother monitoring interfaces. (Except the PC connection    port, the PC port can be connected to an external power supply).

When using the fast charge trigger module,please do not connect equipment that cannot withstand high voltage to any monitoring interface.

After using the PD trigger/monitor/conversion/read E-Marker cablefunction, please turn the PD communication switch in the lower rightcorner back to the OFF position.

Do not charge the phone after the fast charge is triggered.