DTECH 6ft USB to TTL Serial Cable 3.3V 3 Pin TX RX Signal UART Adapter Genuine FTDI FT232RL Chip Debug Cord Compatible with Windows 11 10 8 7 Linux

DTECH 6ft USB to TTL Serial Cable 3.3V 3 Pin TX RX Signal UART Adapter Genuine FTDI FT232RL Chip Debug Cord Compatible with Windows 11 10 8 7 Linux

6 ft short USB to TTL serial adapter FTDI chip with 3 pin 0.1” pitch female socket header connects devices with 3.3 V logic level UART signals interface to a laptop via USB 2.0 port (232r-3v3) 3.3v TTL to USB cable is built with a genuine FTDI FT232R chip module in USB 2.0 type A male terminal for wider compatibility and reliable data transfer rates 6 feet USB to UART TTL serial cable 3.3 volt features 3 way output 2.54mm flying lead jumper wires to provide access to Tx transmit, Rx receive and GND (TTL-232R-3V3) USB to TTL 3.3v built with FT232 FTDI chip on the PCB board has configurable internal EEPROM and 3V3 UART signals can be individually inverted by configuring the EEPROM USB-TTL converter chord is compatible with Windows 11, 10, 8, 8.1, 7, 2008/XP/Vista/CE, Mac OS, Linux; ideal USB 2.0 debug data communication cord for Vendor ID re-write, mini computer, router, printer, GPS, set top box, transmitter, flash firmware on hard drive, video display terminal, etc. 6-Foot USB TTL serial adapter built with FTDI FT232RL chip for 3.3V logic level serial communication (rx, tx and GND)
It is built with FT232r chip that its royalty-free VCP driver allow for communication as a standard COM port and D2XX ‘direct’ drivers provide DLL application programming interface; a great conversion data cord to meet with your needs of debugging, boot-loading, programming, etc.

The original FTDI FT232 chip is embedded in the USB-A end; 3 way 0.1” header connector with GND (ground), RX and TX at 3V3 logic level.

Applications:
Upgrading Legacy Peripherals to USB
Interface Microcontroller UART or I/O, FPGA / PLD to USB
As a switching device in driving lamps and relays
Replace MAX232 type level shifters allowing for direct connection of products to PC
Used in processors of mini computers like DEC VAX
Industrial Control, USB Software, Hardware Encryption Dongle, printer, video display terminals, Oscilloscope, measurement device, microprocessor, light and remote controller, etc.

The I/O pins of the USB to uart wire are configured to operate at 3.3v logic level - Entire USB protocol handled by the electronics in the cable;
UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity;
Data transfer rates from 300 to 3M baud rate at TTL levels;
Internal EEPROM with users writable area; Supply voltage comes from USB bus, no external supply required;
UHCI / OHCI / EHCI host controller compatible

Interfaces: USB 2.0 type A Male Port ; 3 pin Female Socket flying leads
Supports Windows 2008, XP, Vista , CE 4.2, 5.0 and 6.0, Windows 11, 7, 8, 8.1, 10; Mac, Linux
NOTE: If any installation or usage issues, please email us or you may download a driver and usage guide on FT232 chip official website

What’s Included
1x Type A male USB to Serial TTL Level Converter Cable 6 ft
1x Manual