Smaeti 2X Urethane Band Saw Tires, 12" x 7/8" x .095", Fits for Craftsman 113.24341 113.243411 113.24344 113.2435- No Adhesive Needed

Smaeti 2X Urethane Band Saw Tires, 12" x 7/8" x .095", Fits for Craftsman 113.24341 113.243411 113.24344 113.2435- No Adhesive Needed

Urethane Bandsaw Tires 12″ x 7/8″ x .095″, 2 pack, They can be installed on any 12″ band saw that requires a 7/8″ wide and 3/32″ thick tire Longer belt life – Made of Urethane, The long-lasting upgrade to rubber belts, Urethane band saw tires most certainly outlast rubber band saw tires and plastic band saw tires. Urethane band saw tires will not dry rot like rubber or plastic tires. This alone provides you with an exceptional value over other types of band saw tires.From improved performance and safety to reduced downtime Fast, easy installation –no adhesive is needed for proper installation. Urethane tires are specifically designed to stay in place without any type of adhesive and can be stretched to fit. This makes them even easier to install and even easier to remove if necessary 12" x 7/8" Tire Fits for Craftsman 103.2425 103.2426 103.24280 113.242 113.24201 113.2429 113.2433 113.24331 113.24261 113.24336 113.243311 113.2434 113.243401 113.24341 113.243411 113.24344 113.2435 113.24721 113.24731 113.24741 113.24744 113.248211 113.248212 113.24829 113.24832 113.248321 113.248322 113.24844 113.24851 119.22400 351.22400, Also fits for any band saw that needs a 12" x 7/8" x .095"" tire.The actual wheel diameter can be 11-6/8" to 12-1/2" in diameter The upgraded belt is made of polyurethane material, which does not dry and rot like other types of tires compared to plastic or rubber tires. Using polyurethane tires can stretch, which increases their efficiency and life expectancy Urethane Bandsaw Tires 12" x 7/8" x .095", 2 pack

How to install:
First, After disassembling old "tires", clean up the gummy debris left on the wheels.

Mounting:
Used a clamp to hold the tire on the wheel in one spot, and then used a screwdriver to pry the rest of the tire on. This made installation relatively easy

Uniform stretch:
After mounting, removed the clamp and pushed the shaft of the screwdriver completely under the tire, so it was between the tire and rim. Then ran the screwdriver around the wheel several times to make sure the tire was uniformly stretched around the wheel.

Seating the tire:
Next, made sure the tires were properly seated in the groove on the wheels, rolled the wheel on a concrete floor, pushing down pretty hard with your hands, so the concrete would forced the tire into the groove.

After mounting, reinstalled the wheels and readjusted everything, finish!

Urethane band saw tires no adhesive needed, but need to be stretched on. If your new band saw tire is too tight to fit onto the wheel, submerged the new tire under hot water for a few minutes, this will make things easier.