WYDDDARY Floor Grinding And Trimming Machine Hand Push Cement Ground Grinder Polishing Machine with 3pcs Grinding Heads 220V

WYDDDARY Floor Grinding And Trimming Machine Hand Push Cement Ground Grinder Polishing Machine with 3pcs Grinding Heads 220V

Parameter: Voltage: 220V; Power: 3kw; Phase number: 1; Number Of Grinding Heads: 3pcs; Working width: 330mm; Rotational speed: 1440r/min; Work Depth: 0-3mm Versatile Wall-to-Floor Grinding Capability: Unique detachable design allows grinding right up to wall edges, while the 4-position adjustable chassis provides flexible operation angles. Foldable arms and height-adjustable components make it perfect for both open floor areas and tight spaces near walls High Efficiency: This heavy-duty grinder features a powerful 3KW pure copper motor with 1440r/min rotational speed, delivering exceptional performance for concrete floor preparation Enduring and Relicable: Features rubber damping wheels for smooth operation and a lifting hand wheel for precise control on uneven surfaces. The foldable design and adjustable components make transportation and storage convenient without compromising stability during use Note: Give away 5 meters of wires. The maximum length of the wire connected to the machine can be 90 meters. The specification is three-core wires. Each wire should not be less than 6 mm² of pure copper wire. The wire must be connected to the air switch, and the rated current of the air switch is about 63A

Parameter:

Voltage: 220V

Power: 3KW

Phase number: 1

Working width: 330mm

Rotational speed: 1440r/min

Number of grinding heads: 3pcs

Work Depth: 0-3mm

Note:

Give away 5 meters of wires. The maximum length of the wire connected to the machine can be 90 meters. The specification is three-core wires. Each wire should not be less than 6 mm ² of pure copper wire. The wire must be connected to the air switch, and the rated current of the air switch is about 63A. As shown in the picture of wiring mode, please contact us if you have any questions.

Precautions for use:

1.The input voltage should not be too low.

2.When using, first lift the machine head off the ground,and then turn on the switch. When the machine head rotates normally, gently place it on the ground.

3.When working, the machine head swings left and right, then moves forward, and cannot stop in place.

4.In case of power failure during operation, the switch should be reset and cannot be stopped at the original position to avoid burning the motor when the power is on.

5.If a generator is used to provide power, the output power of the generator must be at least 9KW.