TMC2208 Stepper Motor Driver with Heat Sink for 3D Printers Silent Operation and UART Mode Compatibility

TMC2208 Stepper Motor Driver with Heat Sink for 3D Printers Silent Operation and UART Mode Compatibility

Performance: TMC2208 stepper motor driver offers silent operation and 256 subdivisions. Current: Stepper motor driver supports up to 2.5A current for stable printing performance. Compatibility: 3D printer driver works with UART mode and SGEN L without jumpers. Heat Dissipation: Motor driver module features efficient cooling with aluminum alloy heat sink. Durability: Stepper motor driver is built with aluminum alloy for long lasting use. Spec:
Item Type: Stepper Motor Driver
Material: Aluminum alloy
Output Current: 1.4A
Recommended Operating Current: 1.2A
Microstep: 256 microstep subdivision
Configuration: STEP, DIR OR UART
Load Driving Voltage Range: 5-36V
IC Logic Operating Voltage: 3.3V, 5V

How to Use:
1. Please pay special attention to the drive direction, do not insert the reverse2. Be sure not to connect the motor when measuring the voltage, otherwise it is easy to burn the problem moving.3. When measuring the voltage should be connected to the power supply, do not just connect the USB power supply.4. When used on the printer control board, please retain the three jumper covers under the jack.5. Before adjusting the knob must be carried out in the case of power failure, adjust the completion of the power measurement, to prevent the driver or the motherboard burned6. paste heat sink, please pay attention to the distance between the heat sink and the pins, otherwise it will cause a short circuit between the heat sink and the pin corner 7. Dynamic working conditions, please do a good job of heat dissipation (heat sink and cooling fan), to prevent the drive overheating of the abnormal work.

Package List:
1 x Stepper Motor Driver
1 x Heat Sink
1 x Screwdriver